HyLoft 80842-10 Installationsanleitung PDF herunterladen (Seite 2)

INSTALL DOWNRODS

Ceiling Joist

INSTALL CORNER RODS & SUPPORT BARS

Adjust Height

from 17" to 26"

Adjust Width

Mount from 27" to 37"

apart (from outside edges

of ceiling plates)

Using a Stud/Joist finder

locate any 2 Joists

at the best distance

for your storage items

IMPORTANT-READ THROUGH ENTIRE INSTRUCTIONS BEFORE BEGINNING INSTALLATION Locate the ceiling joists in

the area of desired installation and determine the direction in which they are running. The ceiling mounting plates on

Downrods(A) are installed parallel to the ceiling joists. Refer to the diagram below for additional installation clarification.

Place Downrod (A) against ceiling under joist location and mark holes running parallel with the

joist. Pre-drill each hole location using a 3/16" drill bit.

Install Downrod (A) using a

Socket Wrench or Nut Driver and two (2) 5/16" x 2 1/2" Lag Screws (F). DO NOT OVER

TIGHTEN.

From the outside edge of the ceiling mounting plate of the Downrod (A) just installed, measure

from 27" to 37"(depending on size of storage area desired) inches along ceiling joist and mark

this location. This mark will be the OUTSIDE edge of the second ceiling mounting plate of

second Downrod (A). Install second Downrod (A) and make sure it lines up with the first

Downrod (A) installed on the joist.

Repeat to install the remaining two (2) Downrods on a joist which can vary from any distance

apart from the 1st joist (depending on size of items to be stored).

IMPORTANT: Downrods must be mounted perfectly in line and square to each other.

Rub some bar soap or add a drop of

liquid soap to the threads of the lag screws to ease installation.

Assemble (2) Corner Rods (B & C) to each of the Support Bars (D & E) by sliding one inside the other as shown. Determine

the length down from the ceiling you want the unit to hang (from 17" to 26").

Attach the Corner Rod and Support Arm assembly to Downrods (A) at the predetermined length using two (2) 1/4" x 1.25"

Hex Bolts (G) and two (2) serrated Hex Nuts(H) for each connection to all Downrods (A) using a Wrench or Nut Driver. Adjust

width & fasten Support Bars (D & E) to each other and to Corner Rods (B & C) with two (2) serrated Hex Nuts (H) at each

connection.

IMPORTANT: Do not over tighten the lag screws (max 10 ft. lbs).

They only need to be snug down, no more. Do not use an impact driver.

Page 3 of 12

1 2 3 4 5 6 7 ... 12 13

Keine Kommentare

HyLoft 80842-10 Installationsanleitung Seite 2