HyLoft 50175-10 Installationsanleitung PDF herunterladen (Seite 3)

INSTALL GRIDS

Make sure that all nuts, bolts and screws are tight. Do not load with more than 300 lbs, evenly distributed.

Place Grids(A) across the two hanging

Support Arm (D) assemblies making

sure the long wires of the Grids (A) are

facing down and overhang is even on

both sides. Quad wires go to the inside

on the center Grids(A) and to the outside

on the outer Grids(A).

Fasten 2 center Grids(A) to Support Bars

(D) through the quad wire section of the

Grids (A) using (4) ¼ x 2" Carriage Bolts

(J) and ¼" serrated nuts (K) as shown.

DO NOT TIGHTEN AT THIS TIME.

Attach two sets of outer Grids (A)

together using two 6-32 x 2" Carriage

Bolts (F), 6-32 washers (H), and 6-32

nuts (G) on both sides. Tighten center

Grids (A) to Support Bars(D).

Quad

wires

Quad

wires

Quad

wires

1 2 3

Keine Kommentare

HyLoft 50175-10 Installationsanleitung Seite 3